|
Product Specifications
Library Computer Table #1271715900
Product Description:
29" desk height computer table,
36" wide and 30" deep with cantilevered legs, plastic laminate top,
solid oak components, and wire management system.
Materials:
Lumber: All
exposed wood shall be Northern Red Oak free from all detrimental defects
and selected in uniform grade and color. Air and kiln dried to final
moisture content of 5 to 6%. This material will then be allowed to
condition a minimum of 30 days before machining.
Cores: All cores
are to be Type 1, Grade B, Class 2 panels and shall have a medium
density of 35 to 50 lbs./cubic foot. All specifications will follow the
guidelines outlined by the National Particle Board Association
specification AMST-D-1037-63T.
Veneer: Exposed
veneers shall be Grade "A" plain-sliced Red Oak not less than 1/28"
thick. Face veneers shall be free from splits, patches and detrimental
defects.
High pressure laminates:
Laminate material shall be .039 to .050" thick and will meet NEMA LD3
standards. Backing sheet not less than .020" shall be used where
appropriate.
Finishing:
Three-step process incorporating oil based stain to specified color;
Power Process Opticlear Pre-Catalyzed 25 degree catalyzed lacquer
sanding sealer and topcoat 30-35 sheen. All parts sanded between coats.
Hardware: KV1547
Nickel finish Desk Top Fasteners, LA-11248-3 Polished Brass Piano Hinge,
.04 Gauge with #5x5/8" Polished Brass Screws. 1 1/8" ¼-20 GI-643-411-081
Levelers. ¼-20 TN106SB8 Leveler insert. FEXSF72 White Tray Wire
Management. Confirmat Connector 264.47.236
Component
Specifications:
Tabletop is 1 1/8" 45 lb. Particleboard substrate
with laminate backer sheet on underside and High Pressure Plastic
laminate on the top. Laminate shall match in color and grain pattern the
stained or natural finish of the solid oak components. Tabletop is
banded with ¼" thick solid red oak lumber before top laminate is
applied, and finished with a ¼" round over edge detail. A 3"x 28"
flip-up door with a 1¼" x 3" notch for wire management is included on
the back edge of the tabletop. A ¾" backsplash, 5" wide and 36" long is
fastened to the tabletop 1¼" above the worksurface height.
Modesty panel is ¾" thick Oak Veneer MDF and
extends 18" downward from the underside of the worksurface. The bottom
edge is banded with ¼" thick solid oak. The grain runs in a vertical
direction. Modesty panel is fastened to the legs and tabletop with (3)
¾" x ¾" solid oak cleats, drilled and countersunk to accept #8 x 1 ¼"
square drive drywall screws.
The legs are 1" thick, 12" wide oak veneer MDF with
¼" solid oak banding on the vertical edges. This piece is blind tongue
and grooved into the top and bottom horizontal leg members that are 1¼"
x 2¼" x 21" solid oak. The leg assembly is fastened to the worksurface
with desk top fasteners. |
